Donor PCB main controller IC: 040103400 (Printed on the main controller chip, begin with 0401***).
This is a donor hard drive pcb board to be used as a donor part for hard drive repair and data recovery purposes. Sometimes the hard drive failure is caused by a pcb board failure: No power, No Spin, No Sound; Burning smell; PCB is extremely hot; Hard drive makes clicking sound, never stop; Obvious damage on the PCB board; The hard drive does not spin up,either no sound or can hear a quiet tickling sound; Power surge; Wrong power adapter was used to power up the drive. If your drive will not spin up at all, and wasn't dropped, chances of success with replacing the PCB board are quite good.
040103400 Maxtor Donor HDD PCB Board 301351100
Note: This board is made to be an identical and functional donor for your PCB board, therefore repairing your hard drive and saving you expensive data recovery charges. We recommend buying this item when you are sure it is the PCB. If the BIOS information is not compatible with your HDD, there is no way to read the HDD's data. Because of this, we should use the original PCB's BIOS when we swap PCB. BIOS CHIP SWAPPING IS A MUST.
Real in stock: We have over 1,000 types of PCBs on offer, real in stock. 100% tested working before shipment.
Swapping the hard drive circuit boards, you should know:
- For Seagate, Western Digital, Samsung, Toshiba & Fujitsu hard drives, the Board Number must be the same.
- For Hitachi 3.5" & Maxtor hard drives, the Main Controller Chip number must be the same.
- For Hitachi 2.5" hard drives, the White Label number must be the same.
- PCB version: REV A, REV B, REV C, REV D, REV E, REV P1, REV P2 can be used as the same.
